Masterclock NTDS29 Manual do Utilizador descarregar pdf (Página 6)

Masterclock NTDS Series User Manual – v2 – December 2012

Mounting

DESIGNED FOR WALL, RACK OR TABLE MOUNT

Your NTDS clock is designed to fit a variety of surfaces and

environments supported by these sturdy brackets.

WALL MOUNT BRACKET

For the smaller NTDS clocks a single wall mounting bracket is

supplied which has been designed to fit on either a standard 2”x

4” or 4” x 4” conduit box. Mount the bracket on the wall/conduit

box, attach the power cord and CAT5 Ethernet patch cable and

secure the NTDS to the bracket using the supplied retaining

screws. See page 7 for a plan view with measurements.

Larger clocks require two such brackets.

PLAN VIEW OF WALL MOUNTING BRACKET

(see page 7)

Designed to fit on either a standard 2”x 4” or 4” x 4” conduit

box. Mount the bracket on the wall/conduit box, attach the

power cord and CAT5 Ethernet patch cable and secure the NTDS

to the bracket using the supplied retaining screws.

RACK MOUNT BRACKET

Attach the Cat 5 cable and/or power cord, and then secure the

clock to the equipment rack, cabinet or wall.

SWIVEL MOUNT BRACKET

Mount both swivel brackets to the wall, attach the Cat 5 cable

and/or power cord and secure the clock to the brackets using

the supplied retaining screws. Adjust the angle to provide the

best viewing.

TAKE CARE DURING INSTALLATION

Power and low voltage signal wiring should be installed

according to local electrical codes and to enable access to the

back of this device.

Do not route power or signal cables between the case and the

wall (along the exterior of the wall), which may pinch the power

or signal cable and create a hazardous condition.

1 2 3 4 5 6 7 8 9 10 11 ... 37 38

Sem comentários

Masterclock NTDS29 Manual do Utilizador Página 6